Tutorial: How To Update Your Pioneer4You IPV3 Li 200W

Did you recently purchase the new Pioneer4You IPV3 Li but aren’t sure how to update it? Today we are going to go over the steps to update your IPV3 Li to 200 Watts. At the bottom of this tutorial, we have also included our video tutorial on how to update your IPV3 Li Temperature Control box mod. If you have any additional questions or comments, feel free to leave a comment down below!

 

Step One: Download the program file that allows you to update your IPV3 Li as well as the actual update file. You can download the IPV3 Li files here.

Download “New SXi Upgrade Package”

Download “IPV3 Li 200watt upgrade software with Ti01 and Nickel 200 TC”

Step Two: Open and install “New Sxi Upgrate Package”

Step Three: Remove both batteries from your IPV3 Li and connect your IPV3 Li to your computer with the included USB cable.

Step Four: In the SXi program, go to the connection section and install the required drivers. If no driver is shown, try using a different USB cable. The USB cable that came with the unit I updated did not work correctly. If this does not work, try using a different USB slot on your computer.

Step Five: Hit “connect” in the connection section. Your IPV3 Li should now be connected.

Step Six: Return to the main screen in the SXi program and go to the update section. In the update section, select the file that you downloaded (“IPV3 Li 200watt upgrade software with Ti01 and Nickel 200 TC”).

Step Seven: Click “update”. After the device is done updating, you will have the latest firmware update on your IPV3 Li. Vape on!

 

 

2 thoughts on “Tutorial: How To Update Your Pioneer4You IPV3 Li 200W

  1. George says:

    Thanks friend it worked on windows 10 just have to set it up so with windows 7 compatibility and you’ll find the driver real easy instructions thanks

Leave a Reply

Your email address will not be published. Required fields are marked *